The Ship Model Forum

The Ship Modelers Source
It is currently Wed Jul 09, 2025 12:35 am

All times are UTC - 6 hours [ DST ]




Post a reply
Username:
Subject:
Message body:
Enter your message here, it may contain no more than 60000 characters. 

Font size:
Font colour
Options:
BBCode is ON
[img] is ON
[flash] is OFF
[url] is ON
Smilies are OFF
Disable BBCode
Do not automatically parse URLs
Question
type everything in between the quote marks: "N0$pam" Note the Zero:
This question is a means of preventing automated form submissions by spambots.
   

Topic review - working with 3D printed naval crewmen
Author Message
  Post subject:  Re: working with 3D printed naval crewmen  Reply with quote
Their figures in 1/350 are even more difficult they way they have them all crowded onto a small wafer. If only they would print them in a row on a long runner. They would also be easier to paint.
:wave_1:
Post Posted: Wed Jan 06, 2021 12:06 pm
  Post subject:  working with 3D printed naval crewmen  Reply with quote
Eureka! My experiment payed off!! If you get 3d printed crewmen in 1/200 scale(what I'm working in at the moment), you might encounter the difficulty of getting them of their base. I'm referring to the ones from NorthStar (very little frosting and no "webbing" between the legs) which are excellent but still very brittle; so brittle you usually make amputees out of them when separating them from the base they were printed on. What I've discovered is if you heat a cup of water in the microwave and dip the base/crewmen in and wait about 30 seconds, it softens them up enough to separate with a razor(I use a straight edge blade) by shaving them off. It's a timed event and work in groups before the resin gets hard. Then repeat. It gives you the individual crewmen with all their body parts remaining attached..Use the same technique when cleaning up the individual crewmen..
Post Posted: Tue Jan 05, 2021 9:28 pm

All times are UTC - 6 hours [ DST ]


Jump to:  
Powered by phpBB® Forum Software © phpBB Group