The Ship Model Forum

The Ship Modelers Source
It is currently Fri Aug 01, 2025 8:13 am

Board index » ModelWarships.com general forum » FAQ

All times are UTC - 6 hours [ DST ]



Post a reply
Username:
Subject:
Message body:
Enter your message here, it may contain no more than 60000 characters. 
Font size:
Font colour
Options:
BBCode is ON
[img] is ON
[flash] is OFF
[url] is ON
Smilies are OFF
Disable BBCode
Do not automatically parse URLs
Question
type everything in between the quote marks: "N0$pam" Note the Zero:
This question is a means of preventing automated form submissions by spambots.
   

Topic review - Solder for a cage mast?
Author Message
EJFoeth
  Post subject:  Re: Solder for a cage mast?  Reply with quote
Hand solder should just work fine. If you have good solder and good flux, then you'd be able to solder the rod (or wire even). I put my experience here.
Post Posted: Sat Dec 14, 2013 3:54 am
Jon C Ryckert
  Post subject:  Solder for a cage mast?  Reply with quote
My experience with solder is like most people, by hand with an iron. If one was to make a cage mast for a model out of brass rod, what would be the preffered method. If there is one. Thanks for any replies.
Post Posted: Fri Dec 13, 2013 5:57 pm

Board index » ModelWarships.com general forum » FAQ

All times are UTC - 6 hours [ DST ]

Jump to:  
Powered by phpBB® Forum Software © phpBB Group