Need ID on a ship...
Moderators: Timmy C, Gernot, Olaf Held, JWintjes
- MichelB
- Posts: 1689
- Joined: Tue Jan 11, 2005 10:26 am
- Location: The Netherlands
Need ID on a ship...
Can someone ID this scruiser? Note the mast in front of the bridge? Photograph taken around the 1920's in the Netherlands.
Rough guesses welcome...
Rough guesses welcome...
You do not have the required permissions to view the files attached to this post.
If all else fails, a complete pig-headed refusal to see facts in the face will see us through. - General Melchett
- chuck
- Posts: 3384
- Joined: Mon Jan 10, 2005 1:21 pm
- Location: equidistant to everywhere
Re: Need ID on a ship...
A 1890s era Holland class cruiser on the way to being scrapped?
Assessing the impact of new area rug under modeling table.
- MichelB
- Posts: 1689
- Joined: Tue Jan 11, 2005 10:26 am
- Location: The Netherlands
Re: Need ID on a ship...
That's what a lot of people seem to think, but they never had their mast in front of the bridge, and had different hull lines.
If all else fails, a complete pig-headed refusal to see facts in the face will see us through. - General Melchett
-
Gone Asiatic
- Posts: 836
- Joined: Tue Jan 11, 2005 7:44 pm
- Location: Zipangu - Jipukuo
Re: Need ID on a ship...
Perhaps a decommissioned ship from another navy sold to the Netherlands for scrap?
Actually, it has a flag flying from its aft mast, so unlikely decommissioned. Perhaps under tow after an
engineering casualty.
Actually, it has a flag flying from its aft mast, so unlikely decommissioned. Perhaps under tow after an
engineering casualty.
No Quarter Asked - None Given


- JWintjes
- Posts: 1223
- Joined: Mon Jan 10, 2005 11:41 am
- Location: turning into a power-hungry Yamato-models-munching monster... buahahahaha...
Re: Need ID on a ship...
The first thought I had was also a Holland class, but apart from the things Michael already mentioned the section behind the main mast is far too long for a Holland, these being fairly symmetrical ships.
It has a certain Russian look to it, I'd say.
Jorit
It has a certain Russian look to it, I'd say.
Jorit

- Rob
- Posts: 1067
- Joined: Fri Jan 14, 2005 10:08 am
- Location: Cornwall
- Contact:
Re: Need ID on a ship...
I would have guessed at Utrecht?
Cheers,
Rob
Cheers,
Rob
IPMS Fine Waterline Special Interest Group
- Rob
- Posts: 1067
- Joined: Fri Jan 14, 2005 10:08 am
- Location: Cornwall
- Contact:
Re: Need ID on a ship...
If not Utrecht, then my other guess is a German Gazelle class?
Cheers,
Rob
Cheers,
Rob
IPMS Fine Waterline Special Interest Group
- MichelB
- Posts: 1689
- Joined: Tue Jan 11, 2005 10:26 am
- Location: The Netherlands
Re: Need ID on a ship...
My current idea is one of the older italian cruisers: Puglia, Elba, Liguria, Lombardia, Etruria, who were scrapped after WW1. But I'm not resting...
If all else fails, a complete pig-headed refusal to see facts in the face will see us through. - General Melchett
- Filipe Ramires
- Posts: 1185
- Joined: Mon Jan 10, 2005 5:56 pm
- Location: Lisbon, Portugal
Re: Need ID on a ship...
The mast ahead of the bridge is a very uncommon feature...it should be helpful to reduce the choice list. Can't find many candidates here that fit this.
"Build few and build fast,
Each one better than the last"
John Fisher
Each one better than the last"
John Fisher
- Filipe Ramires
- Posts: 1185
- Joined: Mon Jan 10, 2005 5:56 pm
- Location: Lisbon, Portugal
Re: Need ID on a ship...
Michel, looking at those italian cruisers you name:
- You can rule out Etruria...she was sunk on the 13th of August 1918 due to an explosion next to her of an ammo barge.
- The other 4 survived the war and were disposed during the 20's.
- You can rule out Etruria...she was sunk on the 13th of August 1918 due to an explosion next to her of an ammo barge.
- The other 4 survived the war and were disposed during the 20's.
"Build few and build fast,
Each one better than the last"
John Fisher
Each one better than the last"
John Fisher
- bengtsson
- Posts: 868
- Joined: Thu Jan 13, 2005 9:32 pm
- Location: northern Minnesota
Re: Need ID on a ship...
Bridge layout looks very like Gazelle class. Funnels match, but look just a touch to thick. Masts fit. The main deck line seems to drop a bit at the very aft end, that doesn't fit a Gazelle. Plenty of them around after the war. Could be a Gazelle. But don't hold me to it.Rob wrote:If not Utrecht, then my other guess is a German Gazelle class?
Cheers,
Rob
Bob B.
- MichelB
- Posts: 1689
- Joined: Tue Jan 11, 2005 10:26 am
- Location: The Netherlands
Re: Need ID on a ship...
Well, the Gazelles had a very prominent ram bow that I can't see here.
If all else fails, a complete pig-headed refusal to see facts in the face will see us through. - General Melchett
- JWintjes
- Posts: 1223
- Joined: Mon Jan 10, 2005 11:41 am
- Location: turning into a power-hungry Yamato-models-munching monster... buahahahaha...
Re: Need ID on a ship...
The hull doesn't match with a Gazelle (though that was my first idea as well) - no sponsons for the 105mm guns. Also, it looks a little bit too large and the tops too substantial.
Jorit
Jorit

- Werner
- Posts: 2299
- Joined: Mon Jan 10, 2005 1:10 am
- Location: (42.24,-87.81)
Re: Need ID on a ship...
The Spanish Estramadura of 1900?
If an unfriendly power had attempted to impose on America the mediocre educational performance that exists today, we might well have viewed it as an act of war.
-- "A Nation at Risk" (1983)
-- "A Nation at Risk" (1983)
- peppe
- Posts: 352
- Joined: Tue Jun 20, 2006 6:50 am
- Location: roma, italia
Re: Need ID on a ship...
may be sms irene or prinzess wilhelm?
peppe
peppe
You do not have the required permissions to view the files attached to this post.
- bengtsson
- Posts: 868
- Joined: Thu Jan 13, 2005 9:32 pm
- Location: northern Minnesota
Re: Need ID on a ship...
She is flying the same flag as the Tug towing her. What does that tell us?
Bob B.
Bob B.
- MichelB
- Posts: 1689
- Joined: Tue Jan 11, 2005 10:26 am
- Location: The Netherlands
Re: Need ID on a ship...
That was standard practice with that towing company. Especially when the ship had already been sold for scrapping. btw. it's the Dutch flag.
If all else fails, a complete pig-headed refusal to see facts in the face will see us through. - General Melchett
- bengtsson
- Posts: 868
- Joined: Thu Jan 13, 2005 9:32 pm
- Location: northern Minnesota
Re: Need ID on a ship...
I kinda thought that, but asked anyways. Desperation?MichelB wrote:That was standard practice with that towing company. Especially when the ship had already been sold for scrapping. btw. it's the Dutch flag.
Wouldn't a simple copy of Jane's fighting ships from the era solve the problem? I don't have any Janes.
Bob B.
- bengtsson
- Posts: 868
- Joined: Thu Jan 13, 2005 9:32 pm
- Location: northern Minnesota
Re: Need ID on a ship...
Okay, I'm going out on a limb here. It could very well be Italian as was suggested earlier. The photo matches say ELBA quite well. The Funnels fit, the masts fit , the hull lines look good. The give away is the huge ventilators between the funnels. The strarboard one shows up perfect on the photo, you can't miss it. Right where it should be between the funnels. There were some other of these ship around after the war. Who know's where they were broken up?
I don't claim to be right
, but this ELBA matches the best of all the ships I've looked at.
Bob B.
I don't claim to be right
Bob B.
Last edited by bengtsson on Mon Mar 24, 2008 10:57 am, edited 1 time in total.
- MichelB
- Posts: 1689
- Joined: Tue Jan 11, 2005 10:26 am
- Location: The Netherlands
Re: Need ID on a ship...
I used my Jane's Fighting Ships of WW1 to get to my recognition silhouttes, then Image Googled the closest matches.
As for the Irene or Prinz Wilhelm, they lack a guns at the foredeck. I believe I see one at the picture.
As for the Irene or Prinz Wilhelm, they lack a guns at the foredeck. I believe I see one at the picture.
If all else fails, a complete pig-headed refusal to see facts in the face will see us through. - General Melchett